RESEARCH IN MOTION LIMITED MX25 Card Type X.25 PAD Chip Set Unidentified I/O Options Printer/diagnostic port Transfer Rate 19.2Kbps Data Bus External [Image] CONNECTIONS Function Label Function Label RS-232 X.25 to DTE CN1 Diagnostic/printer port CN3 RS-232 to X.25 CN2 DC power CN4 network transmission device USER CONFIGURABLE SETTINGS Setting Label Position » Hardware flow control is not being used J401 Open Hardware flow control is being used J401 Closed » Factory configured - do not alter J201 Open » Factory configured - do not alter J402 Open » Factory configured - do not alter J403 Open » Factory configured - do not alter J404 Open DIAGNOSTIC LED(S) LED Color Status Condition ERR Red On A fatal error has occurred (after initial start-up) ERR Red Off A fatal error has not occurred RX1 Red On PAD is receiving data from DTE RX1 Red Off PAD is not receiving data from DTE TX1 Red On PAD is transmitting data to DTE TX1 Red Off PAD is not transmitting data to DTE HP Red On PAD is waiting for an incoming call HP Red Off PAD is busy and not waiting for an incoming call COMP Red On X.25 link to network is good COMP Red Off X.25 link to network is not good RX2 Red On PAD is receiving data from network RX2 Red Off PAD is not receiving data from network TX2 Red On PAD is transmitting data to network TX2 Red Off PAD is not transmitting data to network CONT Red On X.25 call has connected CONT Red Off No X.25 call has connected PWR Red On Power is on PWR Red Off Power is off Note:LEDs will blink during self-test sequence.